Knowledgebase
FAQs, how to guides and solutions to common problems
Data Analysis
- Can I change the resolution of a curve once it has been output from Analysis?
- Choosing Absolute vs Relative Analysis
- How Does SoundCheck's Heterodyne Analysis Algorithm Work?
- How Can I View SoundCheck Data in Offline Mode?
- My DUT Has a Different Sampling Rate Than My Audio Interface. Is There a Way That I Can Analyze Recordings Made on My DUT in SoundCheck?
- Why Does My Normalized THD Measurement Stop at 10 kHz When I Am Measuring to 20 kHz?
Making Measurements
- ★ How Do I Test the Microphone on My Smartphone, Tablet or Other Portable Device?
- When measuring the Phase of a Microphone Array, how should I configure Auto Delay in Analysis?
- Create Limits from Curve Averages
- Change Signal Generator Values with Arrow Keys
- Why are Stweep Stimuli performed from high frequencies to low frequencies?
- Why Does My Sequence Give a “Waveform Is Empty” Error?
Sequence Writing and Editing
- Undo (Ctrl + Z) Options in SoundCheck's Sequence Editor
- Using Limits in the Multimeter
- Creating a Curve in SoundCheck
- Keeping Repeated Data vs. Overwriting Data
- How Do I Save My Preferences as Default for a Display Type?
- Randomize Curve Colors in a Display
Setup and Calibration
- ★ SoundCheck on macOS Big Sur, Monterey, & Ventura
- ★ Installing SoundCheck on macOS 10.15 Catalina
- How do I upgrade AudioConnect 2 or AmpConnect 621 Firmware?
- How can I connect my BQC or BTC to a Bluetooth® device that prompts me for a code during pairing?
- Log4j Vulnerability Statement
- How Can I Create a New SoundCheck Calibration Sequence (e.g. Creating a Subwoofer Equalization Sequence)